|
|
1. Before installation, take the extra thickness of your finished floor into consideration. Using a small piece of underlayment as a spacing guide, cut through the bottom edges of any door mouldings which protrude into the room to allow space for the new underlayment to slide underneath.
2. Nail down any loose flooring with 6d or 8d ring-shank nails.
3. Set the nails below the floor surface and fill any holes or cracks with filler.
4. When installing the new underlayment, stagger the seams of the ply panels, and leave a 1/32" gap between panels to allow for expansion. Leave a 1/8" gap along the walls. Always use the fasteners and fastening pattern recommended by the vinyl floor and plywood manufacturer.
5. If necessary, use ready-mix floor leveler to smooth out any uneven areas where the ply panels meet. Allow it to dry and sand smooth.
Floor tiles are best centered in the room at a doorway for visual appearance. You may want to use a prominent window instead. Keep this in mind when you lay out the floor tile in your room.
1. Measure to find the center of two opposite walls. Use these points to snap a chalk line across the length of the room in the center of the floor, dividing the room in half. Then snap another chalk line perpendicular to the first so the two lines cross in the center of the room. Check where the lines cross with a carpenter's square to make sure they are square.
2. trial fit a row of tiles down both lines to the width and length of the room. (Do not use adhesive or peel off the protective backing). By laying out the tiles in this way, you can get an idea of any adjustments that need to be made to your original reference lines. What you are trying to do is work with as many full tiles as you can. Also, you want to end up with at least half a tile width in the areas where the tiles meet the walls. Adjust the reference lines as necessary to achieve a satisfactory layout.
1. Begin laying the tile from the center of the floor where your two adjusted reference lines cross. Start by laying a tile at the intersection of the lines, then use the lines as a guide as you work your way outward toward the walls in each quadrant.
2. If your tiles are not self-adhesive, spread vinyl flooring adhesive with the trowel's notched edge, combing it out in beaded ridges according to the manufacturer's directions. Spaces between ridges of adhesive should be almost bare.
3. If adhesive oozes up between the tiles, wipe it off immediately with a solvent-soaked sponge or rag. Consult the manufacturer's instructions to determine the appropriate solvent.
4. After you have installed several rows of tile, bond them firmly to the floor by applying pressure and rolling over them with a floor roller or rolling pin.
Hint: When you must kneel on freshly laid tile to continue with the installation, put a piece of plywood between yourself and the tile. It will distribute your weight and reduce the possibility of individual tiles slipping.
5. After laying all the whole tiles that will fit, begin cutting and adhering tiles to fill around the perimeter of the room.
6. For tiles that simply need to be cut to length, place the tile directly on top of the last full tile near the wall. Place another tile against the wall, overlapping the loose tile. Mark and cut the first loose tile using the overlapping tile as a guide. The cut tile will then fit against the wall.
7. For irregularly shaped tiles, make cardboard templates first to prevent waste.
8. Admire that lovely new floor. Then allow it to sit undisturbed for the recommended period of time before walking on it.
|
|
